GLEASON 104 - Gear Tester

Machine Specifications :

The No. 104 Universal Bevel Gear Tester is used for testing the running qualities, as well as tooth spacing and concentricity, of bevel and hypoid gears. A unique feature of the 104 Angular Hypoid Tester is the pivot construction of the drive head, which is used during the rolling test for obtaining a composite check of tooth spacing, profile shape and eccentricity. A calibrated spring provides any desired pressure between the two mating gears from 0 - 5 pounds. An electric brake is provided to give a fine, uniform control of the amount of load applied to the driven spindle during the power running test. Gears are tested in this machine by running them together in pairs, or running one member with a master or sample mate.

Specifications:

• Axial Distance From Spindle Nose to Center of Machine (Minimum/Maximum): 1/2" - 3-1/2"
• Diameter of Gear (Maximum): 4-1/4"
• Offset of Gear Spindle Above or Below Center of Pinion Spindle (Maximum): 1-1/2"
• Range of Shaft Angle: 0-180 Degrees
• Spindles (3-interchangeable): 1 2 3
• Diameter of Taper Hole At Large End: 25/64" 3/4"
• Taper Per Foot: 1/2" 1/2"
• Depth of Taper: 1/2" 1/2"
• Diameter of Hole Through Spindle: 1/4" 1/2"
• Spring Pressure on Drive Head: 0-5 Lbs.
• Range of Horizontal Movement of Drive Head Under Spring Pressure
• on Either Side of Center Line of Spindle: 0.010"
• Speeds:
• Power Test: 875-1750-3500-7000-14000 RPM
• Rolling Test: 7.2 RPM
• Electrical Equipment:
• Main Motor: 1/2 HP, 1800 RPM
• Rolling Test Motor: 1/50 HP, 7.2 RPM
• Miscellaneous:
• Floor Space (Tester): 25" x 25"
• Floor Space (Recorder): 18" x 21"
• Net Weight: 1,450#
• Shipping Weight, Boxed for Export (1 case 4'0" x 3'3" x 5'0"): 1,725#