MODEL #11MN51-D1 AGET DUSTKOP DUST COLLECTOR
EQUIPPED WITH:
- Bag Filter Type
- Accepts 45 gal. Drum
- 1.5 HP - 1.8 Amps/575 Volt, 3 Phase, 60 Cycle Motor
- In machining operations, grinding, drilling, and boring operations it will
- handle up to three machines in simultaneous operation if they are closely
- grouped.
- This combination Chip-Mist Collector is designed for use in machining,
- drifting, boring, screw machining, and grinding operations where there are
- quantities of solid materials mixed with coolants, where a mist collector can
- not operate efficiently.
- In operation, mist, mixed with chips or moisture laden particles, is sucked
- into the Dustkop where the solids are separated from the airstream and then
- deposited into a 55 gallon drum. From the Dustkop clean air is forced upward
- into the Aget Mist Filter where the moister is separated from the air and the
- residual is carried by a tube into a container or one of the sumps of the
- equipment.
- This combination unit is designed for those operations where chips covered
- with oil, wet dust, and other particles of this type are created and are an
- air contaminate.
- Salvage of waste materials is possible when they are of value, in a 55 gallon
- drum which is a standard container and can be replaced at a small cost.
- SPECIFICATIONS:
- Inlet ..................................... 6"
- Spindle Speeds ............................ 3450 RPM
- Overall Height ............................ 108"
- Diameter .................................. 27-1/2"
- Floor Dimensions Height ................... 9,0"
- Length ................... 41"
- Width .................... 30"
- Mist Filter Unit .......................... 27"x36"
- Bin Capacity .............................. 7.3 Cubic Feet
- Inlet Capacity ............................ 5" or 2 4"
- Ratings ................................... 400 To 1000 C.F.M.
- Static Pressure Requirements .............. 6.8 W.G.
- Horsepower ................................ 1/2
- Motor ..................................... 3600 RPM
- Volts ............................... 575
- Amp ................................. 1.8
- RPM ................................. 3450
- Base ................................ 3
- HP .................................. 1 1/2
- HZ .................................. 60
- Operating Range ........................... 400 To 900 C.F.M.
- F.O.B. TRUCK, WARREN, MICHIGAN
- NOTE: This machine was purchased from McDonald Douglas Air Craft Mfg. I
- believe it was new in the 1980's. It is in Very Good condition!