AGET DUSTKOP 11MN51-D1 - Miscellaneous Equipment

Specifications Print Specs
Model: 11MN51-D1
Year:
Stock #: 2673
Machine Specifications
Year
Manufacturer
AGET DUSTKOP

MODEL #11MN51-D1 AGET DUSTKOP DUST COLLECTOR

    EQUIPPED WITH:

  • Bag Filter Type
  • Accepts 45 gal. Drum
  • 1.5 HP - 1.8 Amps/575 Volt, 3 Phase, 60 Cycle Motor
  • In machining operations, grinding, drilling, and boring operations it will
  • handle up to three machines in simultaneous operation if they are closely
  • grouped.
  • This combination Chip-Mist Collector is designed for use in machining,
  • drifting, boring, screw machining, and grinding operations where there are
  • quantities of solid materials mixed with coolants, where a mist collector can
  • not operate efficiently.
  • In operation, mist, mixed with chips or moisture laden particles, is sucked
  • into the Dustkop where the solids are separated from the airstream and then
  • deposited into a 55 gallon drum. From the Dustkop clean air is forced upward
  • into the Aget Mist Filter where the moister is separated from the air and the
  • residual is carried by a tube into a container or one of the sumps of the
  • equipment.
  • This combination unit is designed for those operations where chips covered
  • with oil, wet dust, and other particles of this type are created and are an
  • air contaminate.
  • Salvage of waste materials is possible when they are of value, in a 55 gallon
  • drum which is a standard container and can be replaced at a small cost.
  • SPECIFICATIONS:
  • Inlet ..................................... 6"
  • Spindle Speeds ............................ 3450 RPM
  • Overall Height ............................ 108"
  • Diameter .................................. 27-1/2"
  • Floor Dimensions Height ................... 9,0"
  • Length ................... 41"
  • Width .................... 30"
  • Mist Filter Unit .......................... 27"x36"
  • Bin Capacity .............................. 7.3 Cubic Feet
  • Inlet Capacity ............................ 5" or 2 4"
  • Ratings ................................... 400 To 1000 C.F.M.
  • Static Pressure Requirements .............. 6.8 W.G.
  • Horsepower ................................ 1/2
  • Motor ..................................... 3600 RPM
  • Volts ............................... 575
  • Amp ................................. 1.8
  • RPM ................................. 3450
  • Base ................................ 3
  • HP .................................. 1 1/2
  • HZ .................................. 60
  • Operating Range ........................... 400 To 900 C.F.M.
  • F.O.B. TRUCK, WARREN, MICHIGAN

Print Specs

Browse by Type